RSS Feed (xml)
How to measure the insulation resistance for printed circuit boards ?
By using known load impedance.
By using known load impedance.
Related Posts by Categories
Interview Questions
- what is hybrid parameter
- Why the antenna is called passive element?
- what is the difference between inductance and resistance?
- Why 440volts instead of 660volts in 3 phases of supply system?
- examples of circuit protecting device apart from fuse, circuit beaker, relays, lighting arrestor, switch gears.
- What differences between microprocessor and micro controller
- Steps for Design binary to gray code converter
- What are semiconductor devices
- Which of the following is is used to hold ROM and RAM cards
- what is meant by virtual ground in the op amp ?
- How to convert binary to gray code and vice-versa?
- Electronics interview questions
- What is the formula for power gain?
- Electronics engineer interview questions
- What is Superconductivity
- What is Transponder
- What is Pull-up resistors
- What is BUS
- What is Difference between real ground and virtual ground
- What is Synchronous transmission
- What is Asynchronous transmission
- What is Signal-to-noise ratio
- What is Common-mode rejection ratio (CMRR)
- What is Infinite impulse response (IIR)
Electronics Hoctro | Electrical
No comments:
Post a Comment
Please give valuable comments on this post.