The instrumentation amplifier OPERATIONAL AMPLIFIERS

As suggested before, it is beneficial to be able to adjust the gain of the amplifier circuit without having to change more than one resistor value, as is necessary with the previous design of differential amplifier. The so-called instrumentation builds on the last version of differential amplifier to give us that capability:

This intimidating circuit is constructed from a buffered differential amplifier stage with three new resistors linking the two buffer circuits together. Consider all resistors to be of equal value except for R_gain. The negative feedback of the upper-left op-amp causes the voltage at point 1 (top of R_gain) to be equal to V₁. Likewise, the voltage at point 2 (bottom of R_gain) is held to a value equal to V₂. This establishes a voltage drop across R_gain equal to the voltage difference between V₁ and V₂. That voltage drop causes a current through R_gain, and since the feedback loops of the two input op-amps draw no current, that same amount of current through R_gain must be going through the two "R" resistors above and below it. This produces a voltage drop between points 3 and 4 equal to:

The regular differential amplifier on the right-hand side of the circuit then takes this voltage drop between points 3 and 4, and amplifies it by a gain of 1 (assuming again that all "R" resistors are of equal value). Though this looks like a cumbersome way to build a differential amplifier, it has the distinct advantages of possessing extremely high input impedances on the V₁ and V₂ inputs (because they connect straight into the noninverting inputs of their respective op-amps), and adjustable gain that can be set by a single resistor. Manipulating the above formula a bit, we have a general expression for overall voltage gain in the instrumentation amplifier:

Though it may not be obvious by looking at the schematic, we can change the differential gain of the instrumentation amplifier simply by changing the value of one resistor: R_gain. Yes, we could still change the overall gain by changing the values of some of the other resistors, but this would necessitate balanced resistor value changes for the circuit to remain symmetrical. Please note that the lowest gain possible with the above circuit is obtained with R_gain completely open (infinite resistance), and that gain value is 1.

• REVIEW:
• An instrumentation amplifier is a differential op-amp circuit providing high input impedances with ease of gain adjustment through the variation of a single resistor.

Related Posts by Categories

Electronics Hoctro | Electrical